LED Replacement Kit

Replacement kit includes:

(1) 12V DC LED strip with 10" 22 gauge soldered wire pigtail

(1) Acrylic diffuser strip

(1) Tube of adhesive 

Instructions for Replacing LED Strip

1) Pry out the acrylic diffuser strip using a small flat head screw driver or similar. Start from the curved end of the strip, lift the strip out of the channel and slowly pull the rest of the strip out in stages

2) Remove the led strip from the channel starting from the end without the wires. Once the strip is peeled out, use a set of pliers or similar and pull the wires out from the hole  

3) Replace old strip with the new strip. Peel the adhesive backing off on the new strip and stick it in the channel, firmly pressing down along the entire strip to assure proper adhesion. Feed the wires through the hole

4) Apply a small amount of the included adhesive around the perimeter of the wood channel in the shelf and spread evenly. Peel off the plastic film on both sides of the acrylic diffuser. Lay the acrylic diffuser into the channel on top of the adhesive and press firmly

5) Let the shelf dry laying down with the LED facing upwards for minimum 12 hours